Harry K7ZOV: 1 November 2016 at 03:04 UTC. HOWTO connect the Kenwood TS-590S to the SDR-IQ Software Defined Receiver. Basic setup for digital operation with packages such as fldigi, etc, and digital voice operation using FDMDV. Just my brief experience with cw decoder this afternoon. HOWTO set up the Kenwood TS-590S for Digital Data and Digital Voice Operation. You may also manually enter or change this value. I put cw decoder up against FLdigi in cw mode and found that FLdigi seemed to do just a bit better than cw decoder. Edit the shortcut properties and set it to start minimized, then change the icon to point to the fldigiicon in C:Program Files (x86)Fldigi-3.23.21fldigi.exe. If needed, the computed compensation value will be entered in the Comp control. start /wait fldigi C:Program Files (x86)Fldigi-3.23.21fldigi.exe taskkill /im cat7200.exe exit Create a new shortcut to this file on your desktop. Use low power or a dummy load for the test. Be aware that this may transmit the characters. The time to transmit is measured and compared to the ideal timing, 1200 msec / WPM. The measurement is made by sending a sequence of ten "PARIS " strings at the current CW WPM setting. The calibrate button is used to measure the timing inaccuracy. The combined effect of the three will be to lengthen the key down/up intervals. FLdigi does not support computer generated CW. This is highly dependent on both serial port hardware, pc architecture, and operating system. Use a different port for PTT than you used for radio control. The CW keyline timing may require compensation. If shared, it must not conflict with the PTT line. Select a unique serial port by selecting the port and enabling the Connect button.įor all port selections you need to specifiy the signal line, DTR or RTS, which is used for the keyline. Select shared port use by enabling either the RIGCAT, or Separate PTT box.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |